If you feel like the wax sticked a little to the stamp, you can help yourself by holding the letter or the envelope with one hand and rising the stamp with another. One end is a felt liner pen, while the other is a stamp that creates the perfect wing every time. For the sealing wax I use 30 seconds is a perfect timing. Leave the stamp in place for 10 seconds and then remove it. When it’s still warm and congealed, it’s extremely sticky and if you rise the seal stamp too early semi-fluid wax will plug all the little grooves in the matrix of your seal. This will prevent the wax from sticking to the matrix and even if you don’t rise the stamp in the right moment (which is difficult, especially when you lack of experience), nothing bad will happen. The surface of the matrix needs only to be slightly moist with oil, the fluid cannot drip from the stamp when you rise it. No matter which option you chose, it is important to make sure the matrix of the stamp is metal or ceramic.
Once melted, sealing wax solidify in the matter of seconds. Finding the right moment for rising the stamp is tricky, because it varies from 5-7 seconds to even 30-35 seconds, depending on the type of sealing wax you use, its temperature and amount put on a paper, material the matrix of your stamp is made of, even on the type of paper you use! If the wax is still very runny, leave it a few more seconds and then press your stamp into the wax with some pressure. Be mindful of the size of your stamp when creating the circle. Your circle will look messy on the mat but don’t worry; the result will be unique, and that’s what wax seals are all about. When it’s ready, use it to create a small circle of glue on a craft mat – then fill the circle in with glue, too. I found a free surfing related image (small). As I mentioned earlier, you need to lift the stamp in a correct time, when the wax is cold enough to preserve the pattern of the seal pressed by a stamp matrix, but in the same time hot enough so it won’t stick to the matrix and be lifted with it.
12. Grab your wax seal stamp. Its quality is very good and it’s much cheaper than customised wax seal stamps produced by craftsmen. Too heavy stamps (e.g. some antique ones with lead filling) will squeeze the wax out and the layer remained below the matrix will be too thin to form a distinctive mark. You can use either ordinary sticks or the ones with a candlewick. Nowadays you can chose to either seal the letter itself or the envelope that contains it. 4. Make sure the surface of the envelope or letter is flat. There might be a point in your life when instead of typing an e-mail you would prefer to use older and more sophisticated form of correspondence, like a traditional handwritten letter. Maybe it’s not in the old-school style, vintage wax seal stamp but from the practical point of view it is the easiest option ‘What about a candle? From my own experience it’s better to wait a little too long rather than too short.
However, to avoid common mistakes and to make sure final result will be satysfying, I invite you to read this short guide on how to use wax seals. Crayon wax seals will be as vibrant as traditional sealing wax seals so you’ll no doubt be delighted with the result. Alternatively, wedding wax seal stamp you can hold a crayon directly over a flame above your envelope and let it drip. Extremely important: keep the end of the stick as lower into the flame as possible! Although sealing wax melts in a quite low temperature, it heats up somewhat slowly, so you need a source of constant, stable flame to heat it up enough for melting to occur. Then you need to use a soft but pointy item to carefully hollow the wax out of the grooves on a matrix. Well, if you’d like to create a seal but don’t have any sealing wax to hand, then you’ll need an alternative. One might use a wax seal to officially seal a document, or as part of a notarized document that one might acquire at their local financial institution.
In case you cherished this information as well as you wish to acquire more info regarding wax stamp generously go to the site.